3dhs Extra 300

[Kevin Rochon]

Since it's so quiet on the forum and Michel is very quiet about his new plane it seems I'm the only one building. I'm starting this thread for you Michel, please post some info + pictures. of your progress;)

[flybyfaith]

Did I hear rumors of a new plane?, is it 3dhs?, is it a 50cc?, Michel inquiring minds want to know.:D:D:D

[Burning Head]

Post few pic here first, then in the '' area-51 magazine''...;)

[mdauth]

Ok to start; it is a 3dhs 87" Extra 300 Ship, still small compared to David's planes maybe the next one??

http://www.3dhobbyshop.com/87-Extra-300-SHP--Blue_p_15657.html

Will be equipped with a 60cc on canister with smoke, servo will be HS-7955tg all around, using the EQ10 to power up the servos with two 2s 2600mah lipo and one 2s 1600mah for the ignition. For the graphics I ordered from B&E the same as per my avatar.

[Kevin Rochon]

Finally Michel thank you.

So there is going to be a lot of new stuff this spring and summer.

Keep posting we want to see every bit of glue and screws put on:D

[mdauth]

The rudder is in and installed the elevator servos, little trick I found on rcgroup to add CA in a tight area where the bottle doesn't fit, you take either CF or steel rod put it where you need to apply the CA add the drop on it and it will travel inside to where the rod is sitting, tried it on my servo holes in the stabilizer worked really well.

[Kevin Rochon]

Very good idea Michel:yes: I will use it when installing my Aileron & Flap servos there inside the wing.

[Kevin Rochon]

So far I've used your ideal many time but with a needle or an hex key.

But what's happening with the Extra.

[mdauth]

But what's happening with the Extra.

A lot but no time to post:D:D and it will only fly in the spring so I've got plenty of time.