View Single Post
  #13  
Old 2021-06-15
Michal Michal is offline
Non-WIMAC Member
First Name: Michal
Last Name: Kuczewski
MAAC Number: 97129
WIMAC WINGS: Solo Planes
 
Join Date: Apr 2020
Posts: 145
Michal is on a distinguished road
Usually you need to swap the servo motor wires, to reverse the motor polarity, and the pot end to reverse the pot.
I could not do it in some servos because they were pcb mounted and I did not want to go cutting traces.

The transmitter mixer approach is the best idea. I personally like to standardize my servos to keep minimum spares, so would not like to start customizing them.

Thank you Ricardo. My servo was easier to switch wires. The motor connectors were exposed when I opened the servo and a decoder was attached with a screw. I could pull it out and have a good access to solder wires.
Reply With Quote