Thread: 3DLabPrint P-38
View Single Post
  #13  
Old 2018-05-20
Andrew Fernie Andrew Fernie is offline
Past President
First Name: Andrew
Last Name: Fernie
MAAC Number: 30499
WIMAC WINGS: Instructor Multirotor FPV
 
Join Date: Jan 2007
Posts: 1,238
Andrew Fernie is on a distinguished road
Exploded view

All the parts have been made. Hopefully I don't crash at some point and turn it into the same number (or greater) of pieces.

I managed to combine a few pieces for the right fuselage, and will reprint the left the same way. My first attempt at combining wing parts didn't work (I picked the wrong parts), but looking at the full set of parts I can see better ways of doing it. As examples, the two parts between the center and left/right fuselages should be good, as should the first two pieces outboard of the left and right fuselages. Not sure if I will do that or not.

Andrew
Attached Images
File Type: jpg P1000579.JPG (173.6 KB, 31 views)
Reply With Quote